ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR Click here
2. INSPECT BRAKE BOOSTER ASSEMBLY Click here 3. INSPECT VACUUM WARNING SWITCH ASSEMBLY (a) Start the engine and stop it after 1 or 2 minutes. (b) Remove the battery. Click here (c) Disconnect the connector from the vacuum warning switch assembly. (d) Measure the resistance of the vacuum warning switch assembly. Standard Resistance: 10 kΩ or higher (e) With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly. Standard Resistance: Below 1 Ω (f) Connect the connector to the vacuum warning switch assembly. (g) Install the battery. Click here |
Toyota Avalon Service & Repair Manual > Rear Seat Inner Belt Assembly(for Lh Side): Installation
INSTALLATION PROCEDURE 1. INSTALL REAR SEAT INNER BELT ASSEMBLY LH (a) Install the rear seat inner with center belt assembly LH with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} NOTICE: Do not allow the anchor part of the rear seat inner with center belt assembly LH to overlap the protruding ...