CHECK MODE PROCEDURE DESCRIPTION (a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all of the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic. CHECK MODE PROCEDURE (a) Make sure that the following conditions are met:
(b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Enter the following menus: Powertrain / Transmission / Utility / Check Mode. Powertrain > Transmission > Utility
(f) Change the ECM to check mode and check that the MIL flashes as shown in the illustration. ![]() NOTICE: All DTCs and freeze frame data will be cleared if: 1) the Techstream is used to change the ECM from normal mode to check mode or vice versa; or 2) during check mode, the engine switch is turned from on (IG) to off. Before entering check mode, make a note of the DTCs and freeze frame data. (g) Start the engine. The MIL should turn off after the engine starts. (h) Perform Monitor Drive Pattern for the ECT. Click here
(Or, simulate the conditions of the malfunction described by the customer.) (i) After simulating the malfunction conditions, use the Techstream to check for DTCs and freeze frame data. |
Toyota Avalon Service & Repair Manual > Sfi System: Evaporative Emission System Switching Valve Control Circuit Actuator Stuck Off (P24187F)
DTC SUMMARY DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P24187F Evaporative Emission System Switching Valve Control Circuit Actuator Stuck Off Following condition is met during key-off EVAP monitor: EVAP pressure change when vent valve closed (on) less than 0.3 kPa [0 ...