CAUTION / NOTICE / HINT
HINT:
- The ECM is connected to the CAN communication system. Therefore, before
starting troubleshooting, make sure to check that there are no
malfunctions in the CAN communication system.
- *: Use the Techstream.
PROCEDURE |
1. | VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
| 2. |
CUSTOMER PROBLEM ANALYSIS |
|
NEXT | |
| |
| 3. |
INSPECT BATTERY VOLTAGE | Standard Voltage:
11 to 14 V If the voltage is below 11 V, recharge or replace the battery before proceeding.
|
NEXT | |
| |
| 4. |
CONNECT TECHSTREAM TO DLC3* |
|
NEXT | |
| |
| 5. |
CHECK AND CLEAR DTCS AND FREEZE FRAME DATA* |
(a) Refer to DTC Check / Clear. Click here
|
NEXT | |
| |
|
NEXT | |
| |
| 7. |
SELECT CHECK MODE DIAGNOSIS* | (a) Refer to Check Mode Procedure.
Click here
|
NEXT | |
| |
| 8. |
PROBLEM SYMPTOM CONFIRMATION | (a) Refer to Road Test.
Click here
|
Result | Proceed to | |
Symptom does not occur |
A | | Symptom occurs |
B |
| B |
 | GO TO STEP 10 |
|
A | |
| |
(a) Refer to Symptom Simulation.
Click here
|
NEXT | |
| |
(a) Refer to DTC Check / Clear.
Click here
|
Result | Proceed to | |
DTCs are not output | A | |
DTCs are output | B |
| B |
| GO TO STEP 20 |
|
A | |
| |
(a) Refer to Park/Neutral Position Switch.
Click here (b) Refer to Transmission Control Cable.
Click here
| NG |
| GO TO STEP 18 |
|
OK | |
| |
| 12. |
MECHANICAL SYSTEM TESTS | (a) Refer to Mechanical System Tests.
Click here
| NG |
| GO TO STEP 17 |
|
OK | |
| |
(a) Refer to Hydraulic Test.
Click here
| NG |
| GO TO STEP 17 |
|
OK | |
| |
(a) Refer to Manual Shifting Test.
Click here
| NG |
| GO TO STEP 16 |
|
OK | |
| |
| 15. |
PROBLEM SYMPTOMS TABLE CHAPTER 1 | (a) Refer to Problem Symptoms Table.
Click here
| NG |
| GO TO STEP 21 |
|
OK | |
| |
| 16. |
PROBLEM SYMPTOMS TABLE CHAPTER 2 | (a) Refer to Problem Symptoms Table.
Click here
|
NEXT | |
| |
|
NEXT | |
| |
|
NEXT | |
| |
| NEXT |
| END |
(a) Refer to Diagnostic Trouble Code Chart.
Click here
|
NEXT | |
| |
|
NEXT | |
| |
| 22. |
IDENTIFICATION INFORMATION |
| NEXT |
| GO TO STEP 18 | | 
