Toyota Avalon Service & Repair Manual: Body

BODY

TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY

(a) If necessary, tighten the bolts and nuts on the chassis parts listed below.

  • Front axle and suspension
  • Drivetrain
  • Rear axle and suspension
  • Brake system
  • Engine mounts
  • Other chassis parts

(b) If necessary, tighten the bolts and nuts on the body parts listed below.

  • Seat belt system
  • Seats
  • Doors and hood
  • Body mounts
  • Fuel tank
  • Exhaust system
  • Other body parts

CLEAN OR REPLACE AIR CONDITIONING FILTER

(a) Remove the air conditioning filter.

Click here

(b) Visually inspect the surface of the air conditioning filter.

(c) If the air conditioning filter is contaminated with foreign matter, clean or replace it according to the maintenance schedule.

NOTICE:

Some filters are not able to be cleaned.

ROAD TEST

(a) Check the engine and chassis for abnormal noises.

(b) Check that the vehicle does not wander or pull to one side.

(c) Check that the brakes work properly and do not drag.

(d) Bed-in the parking brake pads.

BODY INSPECTION

(a) Check the body exterior for dents, scratches and rust.

(b) Check the underbody for rust and damage.

If necessary, replace any damaged parts or repair any damaged areas.

FINAL INSPECTION

(a) Check the operation of the body parts.

(1) Hood

  • Auxiliary catch operates properly.
  • Hood locks securely when closed.

(2) Front and rear doors

  • Door locks operate properly.
  • Doors close properly.

(3) Luggage compartment door

Luggage compartment door opens and closes properly.

(4) Seats

  • Seats adjust easily and lock securely in any position.
  • Front seatbacks lock securely in any position.
  • Fold-down rear seatbacks lock securely.

(5) Be sure to deliver a clean car. Make sure to check the following:

  • Steering wheel
  • Shift lever knob
  • All switches and knobs
  • Door handles
  • Seats
    General Maintenance

    Brake

    See More:

    Toyota Avalon Service & Repair Manual > Oil Pump: Disassembly
    DISASSEMBLY PROCEDURE 1. REMOVE CLUTCH DRUM OIL SEAL RING (a) Remove the 4 clutch drum oil seal rings from the stator shaft assembly. 2. REMOVE OIL STRAINER ASSEMBLY (a) Using a T30 "TORX" socket wrench, remove the 2 bolts and oil strainer assembly from the front oil pump cover sub-assembly. 3. REMO ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2020 Copyright www.tavalon.net
    0.0404