Toyota Avalon Service & Repair Manual: HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received (U042481)

Toyota Avalon Service & Repair Manual / Engine / Hybrid / Battery Control / Hybrid Control System / HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received (U042481)

DESCRIPTION

If the hybrid vehicle control ECU receives an invalid compressor control request from the air conditioning amplifier assembly via CAN communication, it will store this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Warning Indicate

U042481

HVAC Control Module to Hybrid Powertrain Control Module Invalid Serial Data Received

Invalid control request received from the air conditioning amplifier assembly

(1 trip detection logic)

Air conditioning amplifier assembly

Does not come on

Master Warning Light:

Does not come on

CONFIRMATION DRIVING PATTERN

HINT:

After repair has been completed, clear the DTC and then check that the vehicle has returned to normal by performing the following All Readiness check procedure.

Click here

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 2 minutes or more.
  5. Turn the power switch on (IG) and turn the Techstream on.
  6. Wait for 1 minute or more with the vehicle stopped, the power switch on (READY), shift lever in P and the air conditioning system on (Lo/COOL MAX, blower speed HI).
  7. Turn the air conditioning system off and wait for 10 seconds or more with the power switch on (READY).
  8. Enter the following menus: Powertrain / Hybrid Control / Utility / All Readiness.
  9. Check the DTC judgment result.

    HINT:

    • If the judgment result shows NORMAL, the system is normal.
    • If the judgment result shows ABNORMAL, the system has a malfunction.
    • If the judgment result shows INCOMPLETE or N/A, perform driving pattern again.

PROCEDURE

1.

CHECK DTC OUTPUT (AIR CONDITIONER)

(a) Connect the Techstream to the DLC3.

(b) Turn the power switch on (IG).

(c) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

(d) Check if DTCs related to the air conditioning system (A/C) are output.

Body Electrical > Air Conditioner > Trouble Codes
Result

Proceed to

DTCs related to A/C are not output.

A

DTCs related to A/C are output.

B

(e) Turn the power switch off.

A

REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY

B

GO TO DTC CHART (AIR CONDITIONING SYSTEM)

    Lost Communication with Hybrid/EV Battery Sensor Module Missing Message (U029A87)

    Utility

    See More:

    Toyota Avalon Service & Repair Manual > Oil Pressure Switch: Inspection
    INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector (b) Disconnect the engine oil pressure switch assembly connector. (c) Start the engine. (d) Measure the resistance according to the value(s) ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0154