Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

DATA LIST

NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Main Body or Smart Key / Data List.

(e) Read the Data List according to the display on the Techstream.

Body Electrical > Main Body > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

Communication D-Door Motor

Connection status between power window regulator motor assembly (driver door) and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication P-Door Motor

Connection status between power window regulator motor assembly (front passenger door) and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication RR-Door Motor

Connection status between power window regulator motor assembly (rear RH door) and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication RL-Door Motor

Connection status between power window regulator motor assembly (rear LH door) and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication Slide Roof

Connection status between main body ECU (multiplex network body ECU) and sliding roof ECU (sliding roof drive gear assembly)*1

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication Master SW

Connection status between multiplex network master switch assembly and main body ECU (multiplex network body ECU)

OK or STOP

OK: Connected

STOP: Not Connected

DTC is output if an error occurs in LIN communication.

Communication Sliding Sunshade ECU

Connection status between roof sunshade ECU and main body ECU (multiplex network body ECU)*2

OK or STOP

OK: Connected

STOP: Not Connected

Not applicable

The Number of DTC

Number of DTCs

0 to 255

Number of stored DTCs

-

  • *1: w/ Sliding Roof System
  • *2: Although the item is displayed on the Techstream, it is not applicable to this vehicle.
Body Electrical > Smart Key > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

# Codes

Number of DTCs

0 to 255

Number of stored DTCs

-

    No Response from Steering Lock ECU (B2786)

    Diagnosis System

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Oil Cooler: Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 1 MOTOR COOLING HOSE HINT: Perform this procedure only when replacement of the motor cooling cooler is necessary. (a) Coat the pipe of the motor cooling cooler with a small amount of ATF as shown in the illustration. ATF Application Area (b) Install the No. 1 mo ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0124