ON-VEHICLE INSPECTION PROCEDURE 1. CHECK STEERING EFFORT (TORQUE) NOTICE: These service operations may affect the SRS airbags. Be sure to read the precautionary notices concerning the SRS airbag system before servicing. Click here (a) Stop the vehicle on a level, paved surface and align the wheels straight ahead. (b) Remove the horn button assembly. Click here (c) Connect the cable to the negative (-) auxiliary battery terminal. (d) Using a torque wrench, check that the steering wheel set bolt is properly tightened. Torque: 62 N·m {632 kgf·cm, 46 ft·lbf} (e) Turn the power switch on (READY) so that the power steering is ready to operate. (f) Turn the steering wheel 90 degrees to the right and check steering effort (torque) with the steering wheel turned. Check in the opposite direction using the same method. Standard Steering Effort (Reference): 5.5 N*m (56 kgf*cm, 49 in.*lbf) or less (g) Align the front wheels facing straight ahead. (h) Turn the power switch off. (i) Disconnect the cable from the negative (-) auxiliary battery terminal. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here (j) Install the horn button assembly. Click here |
Toyota Avalon Service & Repair Manual > Front Camera: Removal
REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during front camera removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced Replacement Part o ...