Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

(a) Pass the hood lock control cable assembly into the engine compartment.

(b) Engage the grommet.

(c) Engage the 5 clamps.

(d) Engage the clamp to install the hood lock control cable assembly.

2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

(a) Connect the hood lock control cable assembly to install the hood lock control lever sub-assembly.

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

Click here

4. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Click here

5. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

Click here

6. INSTALL FRONT DOOR SCUFF PLATE LH

Click here

7. INSTALL HOOD LOCK ASSEMBLY

(a) Apply MP grease to the sliding areas of the hood lock assembly.

(b) Connect the hood lock control cable assembly to the hood lock assembly.

(c) Install the hood lock assembly with the 2 bolts and hood lock bolt.

Torque:

Bolt :

7.5 N·m {76 kgf·cm, 66 in·lbf}

Hood Lock Bolt :

8.0 N·m {82 kgf·cm, 71 in·lbf}

HINT:

The hood lock nut cap is a non-reusable part. Be sure to install it after inspecting and adjusting the hood sub-assembly.

(d) Connect the connector.

8. ADJUST HOOD SUB-ASSEMBLY

Click here

9. INSTALL COOL AIR INTAKE DUCT SEAL

Click here

10. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

HINT:

Use the same procedure as for the RH side.

Click here

11. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH

HINT:

Use the same procedure as for the RH side.

Click here

12. INSTALL FRONT WHEEL LH

Click here