INSTALLATION CAUTION / NOTICE / HINT HINT:
PROCEDURE 1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY
(b) Fully tighten the bolt (A), and then the bolt (B) to install the front shoulder belt anchor adjuster assembly. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} 2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY Click here 3. INSTALL FRONT SEAT OUTER BELT ASSEMBLY
(b) Fully tighten the bolt (A), and then the bolt (B) to install the front seat outer belt assembly. Torque: Bolt (A) : 12.5 N·m {127 kgf·cm, 9 ft·lbf} Bolt (B) : 42 N·m {428 kgf·cm, 31 ft·lbf}
(d) Connect the shoulder anchor of the front seat outer belt assembly with the nut. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} (e) Check that the ELR locks. NOTICE: This check should be performed with the front seat outer belt assembly installed to the vehicle. (1) With the front seat outer belt assembly installed to the vehicle, check that the belt locks when it is pulled out quickly. 4. INSTALL CENTER PILLAR UPPER GARNISH Click here 5. INSTALL CENTER PILLAR LOWER GARNISH Click here 6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY (a) Connect the floor anchor of the front seat outer belt assembly with the bolt. Torque: 42 N·m {428 kgf·cm, 31 ft·lbf} 7. INSTALL LAP BELT OUTER ANCHOR COVER (a) Engage the 3 claws to install the lap belt outer anchor cover. 8. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP Click here 9. INSTALL REAR DOOR SCUFF PLATE (for Gasoline Model) Click here 10. INSTALL REAR DOOR SCUFF PLATE (for HV Model) Click here 11. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP Click here 12. INSTALL FRONT DOOR SCUFF PLATE Click here 13. INSTALL REAR SEAT CUSHION LOCK HOOK (for Gasoline Model) Click here 14. INSTALL REAR SEAT CUSHION ASSEMBLY (for Gasoline Model) Click here 15. CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY (for Gasoline Model) Click here 16. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (for Gasoline Model) w/ Seat Heater System: Click here 17. INSTALL SPARE WHEEL COVER ASSEMBLY (for Gasoline Model) w/ Seat Heater System: Click here 18. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL for A25A-FKS: Click here for 2GR-FKS: Click here 19. INSTALL LUGGAGE TRIM SERVICE HOLE COVER (for HV Model) Click here 20. PERFORM DIAGNOSTIC SYSTEM CHECK for HV Model: Click here for Gasoline Model: Click here 21. INSPECT SRS WARNING LIGHT for HV Model: Click here for Gasoline Model: Click here |
Toyota Avalon Service & Repair Manual > Front Console Box: Removal
REMOVAL PROCEDURE 1. REMOVE CONSOLE BOX POCKET (a) Remove the console box pocket. 2. REMOVE CONSOLE BOX CARPET (a) Remove the console box carpet. 3. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH (a) Disengage the 9 clips as shown in the illustration to remove the lower instrument panel finish panel ...