Toyota Avalon Service & Repair Manual: Does not Recognize Voice Commands Performed to Contact Support Center

Toyota Avalon Service & Repair Manual / Audio, Visual, Telematics / Cellular Communication / Toyota Entune System(for Hv Model) / Does not Recognize Voice Commands Performed to Contact Support Center

PROCEDURE

1.	CHECK COMMUNICATION BASED VOICE RECOGNITION FUNCTION

(a) While paying attention to the condition of the spoken voice command, say "Find a gas station in New York" and check that voice recognition is operating normally.

HINT:

When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Find a gas station in New York" is spoken, "Find a gas station in New York" is displayed in the voice recognition result display area.)
If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
The system cannot recognize voice commands when multiple people are speaking simultaneously.
If the speaking speed is too fast or too slow, the recognition rate may decrease.
The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).

OK:

Voice command is recognized normally.

END

CONTACT SERVICE CENTER

DCM Data Signal Circuit between Navigation ECU and DCM

GPS Mark is not Displayed

See More:

Toyota Avalon Owners Manual > Steps to take in an emergency: If the electronic key does not operate properly
If communication between the electronic key and vehicle is interrupted or the electronic key cannot be used because the battery is depleted, the smart key system and wireless remote control cannot be used. In such cases, the doors and trunk can be opened and the engine can be started by following t ...