REMOVAL PROCEDURE 1. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL LH Click here 2. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL RH Click here 3. REMOVE FRONT CONSOLE UPPER PANEL GARNISH Click here 4. REMOVE CONSOLE BOX POCKET SUB-ASSEMBLY Click here 5. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Click here 6. REMOVE CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL Click here 7. REMOVE CENTER NO. 2 INSTRUMENT CLUSTER FINISH PANEL Click here 8. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET Click here 9. REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY Click here 10. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/o Navigation System)
11. REMOVE NAVIGATION ECU WITH BRACKET (w/ Navigation System) Click here
12. REMOVE NO. 5 ANTENNA CORD SUB-ASSEMBLY (w/ Navigation System) (a) w/o Manual (SOS) Switch:
(2) Disconnect the connector to remove the No. 5 antenna cord sub-assembly. (b) w/ Manual (SOS) Switch:
(2) Disconnect the connector to remove the No. 5 antenna cord sub-assembly. |
Toyota Avalon Service & Repair Manual > Can Communication System(for Hv Model): Check Bus 5 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 15 (CA5H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 16 (CA5L) of the central gateway ECU (network gateway ECU) and termin ...
