DESCRIPTION The blind spot monitor sensor receives yaw rate signals from the airbag sensor assembly (yaw rate and acceleration sensor) via CAN communication. Blind Spot Monitor Master
CAUTION / NOTICE / HINT NOTICE: When checking for DTCs, make sure that the blind spot monitor system is turned on. PROCEDURE
(a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Read the DTCs following the prompts on the Techstream. Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes. Chassis > ABS/VSC/TRAC > Trouble CodesOK: Electronically controlled brake system DTCs are not output.
(a) Turn the engine switch off. (b) Turn the engine switch on (IG). (c) Recheck for DTCs and check if the same DTC is output again. Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes
|
Toyota Avalon Service & Repair Manual > Intelligent Clearance Sonar System(for Gasoline Model): Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not. HINT: Using the Techstream to read the Data List allows the values or states of ...