Toyota Avalon Service & Repair Manual: Outside Air Temperature Sensor (C1652)

DESCRIPTION

When a malfunction signal sent from the air conditioning system via CAN communication is detected by the clearance warning ECU assembly, DTC C1652 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1652

Outside Air Temperature Sensor

Ambient temperature sensor malfunction

Air conditioning system

CAUTION / NOTICE / HINT

NOTICE:

  • After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click here

  • After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

    Click here

PROCEDURE

1.

CHECK AIR CONDITIONING SYSTEM

(a) Using the Techstream, check for DTCs according to the prompts on the screen.

HINT:

After turning the engine switch from off to on (IG), wait 13 seconds or more before checking for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

(b) Clear the DTCs according to the screen on the Techstream.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Clear DTCs

(c) Recheck for DTCs.

Body Electrical > Advanced Parking Guidance/ICS/Intuitive P/A > Trouble Codes

HINT:

  • DTC C1652 is stored when a malfunction signal sent from the air conditioning system is detected.
  • If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1652 will not be output again.
  • If DTC C1652 is output frequently, duplicate the conditions that cause the problem symptoms and perform troubleshooting again, even though the DTC was not output when rechecking for DTCs.

    Click here

Result

Proceed to

DTC C1652 is output

A

DTC C1652 is not output

B

A

GO TO AIR CONDITIONING SYSTEM

B

USE SIMULATION METHOD TO CHECK

    G Sensor Failure (C1647)

    Calibration

    See More:

    Toyota Avalon Service & Repair Manual > Blind Spot Monitor System(for Gasoline Model): Lost Communication with Blind Spot Monitor Slave Module (U0232)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor RH judges that there is a communication problem with the blind spot monitor sensor LH. DTC No. Detection Item DTC Detection Condition Trouble Area U0232 Lost Communication with Blind Spot Monitor Slave Module The blind spot monitor se ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2020 Copyright www.tavalon.net
    0.0506