DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes. Chassis > Parking Assist Camera > Trouble Codes(e) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. Body Electrical > Navigation System > Trouble Codes(f) Check for DTCs. Click here NOTICE: The radio and display receiver assembly outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.
CLEAR DTC (a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Chassis / Parking Assist Camera / Trouble Codes. Chassis > Parking Assist Camera > Clear DTCs(e) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. Body Electrical > Navigation System > Clear DTCs(f) Clear the DTCs. |
Toyota Avalon Service & Repair Manual > Sfi System: Cold Start Ignition Timing Performance (P050B00)
MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine is ...
