Toyota Avalon Service & Repair Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

(a) Check the idle speed.

(1) Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range with the A/C switch off.

Standard Idle Speed:

600 to 700 rpm

NOTICE:

  • Be sure to perform this step with all accessories off.
  • Make sure that the shift lever is in P or N.

(2) Perform a road test and confirm that there are no abnormalities.

(b) Inspect the throttle position sensor.

(1) Connect the Techstream to the DLC3.

(2) Start the engine.

(3) Turn the Techstream on.

(4) Enter the following menus: Powertrain / Engine / Data List / Throttle Position Sensor No.1 Voltage %.

Powertrain > Engine > Data List

Tester Display

Throttle Position Sensor No.1 Voltage %

(5) Fully depress the accelerator pedal and check that the value is 60% or higher.

If the percentage is less than 60%, check the throttle body with motor assembly, wire harness and ECM.

    Installation

    Removal

    See More:

    Toyota Avalon Service & Repair Manual > Rear Door Speaker: Installation
    INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL REAR NO. 2 SPEAKER ASSEMBLY NOTICE: Do not touch the speaker cone. (a) for 8 Speakers: (1) Engage the 3 claws to install the rear No. 2 spea ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2023 Copyright www.tavalon.net
    0.0134