INSTALLATION PROCEDURE 1. INSTALL FUEL PUMP CONTROL ECU BRACKET (a) Install the fuel pump control ECU bracket to the fuel pump control ECU with the 2 bolts. Torque: 4.5 N·m {46 kgf·cm, 40 in·lbf} 2. INSTALL FUEL PUMP CONTROL ECU (a) Install the fuel pump control ECU to the vehicle body with the nut. Torque: 8.0 N·m {82 kgf·cm, 71 in·lbf} (b) Connect the 2 fuel pump control ECU connectors. 3. INSTALL ROOM PARTITION BOARD LH Click here
4. INSTALL PACKAGE TRAY TRIM PANEL ASSEMBLY Click here 5. INSTALL REAR SEAT SHOULDER BELT COVER Click here 6. INSTALL ROOF SIDE INNER GARNISH LH Click here 7. INSTALL ROOF SIDE INNER GARNISH RH HINT: Use the same procedure as for the LH side. 8. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY LH Click here 9. INSTALL ROOF SIDE RAIL GARNISH ASSEMBLY RH HINT: Use the same procedure as for the LH side. 10. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH Click here 11. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH Click here 12. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH Click here 13. CONNECT REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH HINT: Use the same procedure as for the LH side. 14. INSTALL CENTER STOP LIGHT SET Click here 15. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD (w/o Seat Heater System) Click here 16. INSTALL REAR SEAT ASSEMBLY Click here |
Toyota Avalon Service & Repair Manual > Electronically Controlled Brake System(for Gasoline Model): Brake Warning Light Remains ON
DESCRIPTION The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication. If any of the following is detected, the brake system warning light (red indicator) remains on: The skid control ECU (brake actuator assembly) connector is disconnected fr ...