Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: ECU Malfunction (B1003)

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual / Power Source, Network / Networking / Can Communication System(for Gasoline Model) / ECU Malfunction (B1003)

DESCRIPTION

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

B1003

ECU Malfunction

A malfunction in the non-volatile storage of the central gateway ECU (network gateway ECU) is detected.

Central gateway ECU (network gateway ECU)

-

PROCEDURE

1.

RECONFIRM DTC OUTPUT

(a) Connect the Techstream to the DLC3.

(b) Turn the engine switch on (IG).

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.

Body Electrical > Central Gateway > Trouble Codes

Result

Proceed to

DTC B1003 is not output from the central gateway ECU (network gateway ECU)

A

DTC B1003 is output from the central gateway ECU (network gateway ECU)

B
A

USE SIMULATION METHOD TO CHECK

B

REPLACE CENTRAL GATEWAY ECU (NETWORK GATEWAY ECU)

    Air Conditioning Amplifier Communication Stop Mode

    Blind Spot Monitor Sensor Communication Stop Mode

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Window Defogger System(for Hv Model): Terminals Of Ecu
    TERMINALS OF ECU CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (a) Disconnect the G35 air conditioning amplifier assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. Ter ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0181