Toyota Avalon Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL ABSORBER CONTROL ECU

(a) Install the absorber control ECU with the 2 nuts.

Torque:

7.5 N·m {76 kgf·cm, 66 in·lbf}

NOTICE:

  • Avoid any impact to the absorber control ECU.
  • Do not drop the absorber control ECU. If it is dropped, replace it with a new one.

(b) Connect the 2 connectors to the absorber control ECU.

2. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH

Click here

3. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD

Click here

4. INSTALL REAR FLOOR FINISH PLATE

Click here

5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Click here

6. INSTALL BAGGAGE HOLDER NET

Click here

7. INSTALL SPARE WHEEL COVER ASSEMBLY

Click here

8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

9. PERFORM TEST MODE PROCEDURE

NOTICE:

After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode.

Click here

    Components

    Removal

    See More:

    Toyota Avalon Service & Repair Manual > Front Wiper Motor: Components
    COMPONENTS ILLUSTRATION *1 COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY *2 FRONT FENDER TO COWL SIDE SEAL LH *3 FRONT FENDER TO COWL SIDE SEAL RH *4 FRONT WIPER ARM AND BLADE ASSEMBLY LH *5 FRONT WIPER ARM AND BLADE ASSEMBLY RH *6 FRONT WIPER ARM HEAD CAP *7 WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY - - N ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0113