INSTALLATION PROCEDURE 1. INSTALL STEERING WHEEL SWITCH HOUSING (a) When reusing the steering wheel switch housing:
(2) While holding the clamp expanded, engage the claw as shown in the illustration.
(b) When installing a new steering wheel switch housing:
(2) Engage the claw as shown in the illustration.
(3) Remove the pin to install the steering wheel switch housing as shown in the illustration.
2. INSTALL TURN SIGNAL SWITCH Click here 3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY Click here 4. INSTALL TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column) Click here 5. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Crankshaft Position Sensor "A" Circuit Short to Ground (P033511,P033515)
DESCRIPTION The crankshaft position sensor system consists of a No. 1 crankshaft position sensor plate and Magneto Resistance Element (MRE) type sensor. The No. 1 crankshaft position sensor plate has 34 teeth at 10° intervals (2 teeth are missing for detecting top dead center), and is installed on ...