Toyota Avalon Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL NO. 2 INSTRUMENT PANEL WIRE

(a) Connect the 2 airbag connectors of the No. 2 instrument panel wire to the instrument panel passenger airbag assembly.

*a	Airbag Connector
*b	Airbag Connector Locking Button
	Push in this Direction

NOTICE:

• When connecting any airbag connector, take care not to damage the airbag wire harness.
• Be sure to only connect the connectors to each corresponding color.

(b) Push in the 2 airbag connector locking buttons as shown in the illustration to install the 2 airbag connectors to the instrument panel passenger airbag assembly.

(c) Engage the clamp.

2. INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

(a) Engage the 3 hooks.

(b) Push in the instrument panel passenger airbag assembly to engage the 3 hooks.

(c) Install the instrument panel passenger airbag assembly with the 2 screws.

3. INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY

Click here

4. CONNECT NO. 2 INSTRUMENT PANEL WIRE

(a) Check that the engine switch (for Gasoline Model) or power switch (for HV Model) is off.

(b) Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

(c) Connect the connector. NOTICE: When connecting any airbag connector, take care not to damage the airbag wire harness.

(d) Engage the clamp.

5. INSTALL TURN SIGNAL SWITCH

Click here