DESCRIPTION The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication. CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory". Click here PROCEDURE
(a) Check if CAN communication system DTCs are output. Click here
(a) Select the Active Test on the Techstream. Click here
(b) Check the operating condition of the slip indicator light when operating it using the Techstream.
(a) Perform the Active Test of the combination meter assembly (meter CPU) using the Techstream. Click here
(b) Check that the slip indicator light turns on or off in accordance with the Active Test. OK: The slip indicator light turns on or off in accordance with Techstream operation.
|
Toyota Avalon Service & Repair Manual > Can Communication System(for Hv Model): Skid Control ECU Communication Stop Mode
DESCRIPTION Detection Item Symptom Trouble Area Skid Control ECU Communication Stop Mode Any of the following conditions are met: Communication stop for "Skid Control (ABS/VSC/TRAC)" is indicated on the "Communication Bus Check" screen of the Techstream. Click here Communication stop history for "Sk ...
