ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT BRAKE FLUID LEVEL IN RESERVOIR Click here
2. INSPECT BRAKE BOOSTER ASSEMBLY Click here 3. INSPECT VACUUM WARNING SWITCH ASSEMBLY (a) Start the engine and stop it after 1 or 2 minutes. (b) Remove the battery. Click here (c) Disconnect the connector from the vacuum warning switch assembly. (d) Measure the resistance of the vacuum warning switch assembly. Standard Resistance: 10 kΩ or higher (e) With the engine stopped, depress the brake pedal several times to release vacuum from the brake booster assembly, and measure the resistance of the vacuum warning switch assembly. Standard Resistance: Below 1 Ω (f) Connect the connector to the vacuum warning switch assembly. (g) Install the battery. Click here |
Toyota Avalon Service & Repair Manual > Sfi System: VC Output Circuit
DESCRIPTION The ECM constantly generates a 5 V power source voltage from the auxiliary battery voltage supplied to the +B, +B2 (BATT) terminals to operate the microprocessor. The ECM also provides this power to the sensors through the VC output circuit. When the VC circuit has a short circuit, the m ...
