INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY (a) Engage the clamp to connect the wire harness to the transmission floor shift assembly. (b) Connect the shift lock control ECU connector. (c) Engage the clamp to connect the wire harness to the transmission floor shift assembly. (d) Connect the transmission control switch connector. (e) Install the clip to the No. 1 console box duct.
(g) Tighten the 4 bolts in the order shown in the illustration. Torque: 12 N·m {122 kgf·cm, 9 ft·lbf} 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY NOTICE: Before connecting the transmission control cable assembly, check that the shift lever is in N.
(f) After adjusting the shift lever position, check the position and operation of the shift lever. If there is a problem, adjust the shift lever position again. 3. INSTALL CONSOLE BOX ASSEMBLY Click here 4. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Click here 5. INSTALL SHIFT LOCK RELEASE BUTTON COVER (a) Engage the 2 claws and guide to install the shift lock release button cover to the rear upper console panel sub-assembly. 6. INSPECT SHIFT LEVER POSITION Click here 7. ADJUST SHIFT LEVER POSITION Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Theft Deterrent System(for Gasoline Model): Engine Hood Courtesy Switch Circuit
DESCRIPTION The engine hood courtesy switch is built into the hood lock assembly. This switch turns on when the engine hood is closed and turns off when the engine hood is opened. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to ...