REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during transmission control cable assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
CAUTION: To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot. PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION:
2. REMOVE COOL AIR INTAKE DUCT SEAL Click here 3. REMOVE INLET AIR CLEANER ASSEMBLY Click here 4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY Click here 5. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE Click here 6. REMOVE FRONT EXHAUST PIPE ASSEMBLY Click here 7. REMOVE FRONT LOWER NO. 1 FLOOR HEAT INSULATOR
8. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY Click here 9. REMOVE NO. 1 CONSOLE BOX DUCT
10. DISCONNECT ENGINE ROOM MAIN WIRE Click here 11. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY (a) Move the shift lever to N.
|
Toyota Avalon Service & Repair Manual > Fuel Sender Gauge Assembly: Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL SENDER GAUGE ASSEMBLY CAUTION: Perform the inspection in a well-ventilated area. Do not perform the inspection near an open flame. (a) Check that the float moves smoothly between F and E. (b) Check the fuel sender gauge assembly voltage. (1) Apply 5 V between ter ...