INSPECTION PROCEDURE 1. INSPECT COMBINATION SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)
(a) Inspect the "NORMAL" or "NORMAL/CUSTOM" mode switch:
| (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
13 (B) - 16 (GND1) |
"NORMAL" or "NORMAL/CUSTOM" mode switch being pushed and held |
Below 1 Ω | |
"NORMAL" or "NORMAL/CUSTOM" mode switch not pushed |
10 kΩ or higher | If the result is not as specified, replace the combination switch (electric parking brake switch assembly). |
 |
|
*a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) | | |
(b) Inspect the "SPORT" or "SPORT S/S+" mode switch:
| (1) Measure the resistance according to the value(s) in the table below.
Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
12 (P) - 16 (GND1) |
"SPORT" or "SPORT S/S+" mode switch being pushed and held |
Below 1 Ω | |
"SPORT" or "SPORT S/S+" mode switch not pushed |
10 kΩ or higher | If the result is not as specified, replace the combination switch (electric parking brake switch assembly). |
 |
|
*a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) | | |
(c) Inspect the illumination:
| (1)
Apply battery voltage to the combination switch (electric parking brake
switch assembly) and check that the switch illuminates. OK: |
Condition | Specified Condition | |
Battery positive (+) → Terminal 3 (ILL+) Battery negative (-) → Terminal 7 (ILL-) |
Illuminates | If the result is not as specified, replace the combination switch (electric parking brake switch assembly). |
 |
|
*a | Component without harness connected
(Combination Switch (Electric Parking Brake Switch Assembly)) | | | | 
