INSTALLATION PROCEDURE 1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY (a) Temporarily install the park/neutral position switch assembly to the automatic transaxle case sub-assembly with the 2 bolts. NOTICE: Before installing the park/neutral position switch assembly, remove any dirt or rust on the manual valve lever shaft sub-assembly. Be sure to install the park/neutral position switch assembly straight along the manual valve lever shaft sub-assembly while being careful not to deform the plate spring that supports the manual valve lever shaft sub-assembly. If the plate spring is deformed, the park/neutral position switch assembly cannot be installed correctly. (b) Temporarily install the transmission control shaft lever to the park/neutral position switch assembly.
(d) Remove the transmission control shaft lever from the park/neutral position switch assembly.
(f) Hold the park/neutral position switch assembly in that position and tighten the 2 bolts. Torque: 5.4 N·m {55 kgf·cm, 48 in·lbf} (g) Install the transmission control shaft lever to the manual valve lever shaft sub-assembly with the washer and nut. Torque: 12.7 N·m {130 kgf·cm, 9 ft·lbf} (h) Connect the park/neutral position switch assembly connector. 2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
3. INSTALL BATTERY CLAMP SUB-ASSEMBLY Click here 4. INSTALL ECM Click here 5. INSTALL BATTERY Click here 6. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION Click here 7. INSPECT SHIFT LEVER POSITION Click here 8. ADJUST SHIFT LEVER POSITION Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Lane Departure Alert System (w/ Steering Control)(for Hv Model): G Sensor (C1A48)
DESCRIPTION The forward recognition camera receives G sensor signals from the airbag ECU assembly via CAN communication. If the forward recognition camera receives a G sensor malfunction signal from the airbag ECU assembly, DTC C1A48 is stored. DTC No. Detection Item DTC Detection Condition Trouble ...