Inspection INSPECTION PROCEDURE 1. INSPECT TORQUE CONVERTER ASSEMBLY (a) Inspect the one-way clutch. Press on the splines of the stator with a finger and rotate it. Check that it rotates smoothly when turned clockwise and rotates with difficulty when turned counterclockwise.
If necessary, clean the torque converter assembly and recheck the one-way clutch. Replace the torque converter assembly if the one-way clutch still fails the inspection.
(c) Replace the ATF in the torque converter assembly. HINT: If the ATF is discolored or has a foul odor, stir the ATF in the torque converter assembly and drain it before replacing the ATF.
2. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (a) Check the drive plate and ring gear sub-assembly for damage.
(b) Set up a dial indicator and measure the runout at the 6 areas on the drive plate and ring gear sub-assembly surface that contact the torque converter clutch assembly. Maximum Runout: 0.30 mm (0.0118 in.) HINT:
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Motor Generator Control System: Utility
UTILITY ALL READINESS HINT: With "All Readiness", you can check whether or not the DTC judgment has been completed by using the Techstream. Check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs. (a) Connect the Techstream to the DLC3. (b) Turn the powe ...