INSTALLATION PROCEDURE 1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY (a) Coat 2 new transaxle case gaskets with Toyota Genuine ATF WS and install them to the automatic transaxle case sub-assembly. (b) Coat a new transaxle case gasket with Toyota Genuine ATF WS and install it to the counter drive gear sub-assembly. (c) Coat a new No. 1 front oil pump cover gasket with Toyota Genuine ATF WS and install it to the front oil pump assembly. (d) Coat a new No. 2 front oil pump cover gasket with Toyota Genuine ATF WS and install it to the front oil pump assembly.
(f) Engage the clamp to connect the transmission revolution sensor (NC) wire connector.
NOTICE: To prevent it from being pinched between the transmission valve body assembly and the transmission case side cover, do not let the transmission revolution sensor (NC) wire ride up over the area shown in the illustration. 2. INSTALL TRANSMISSION WIRE Click here 3. CHECK AUTOMATIC TRANSAXLE SYSTEM NOTICE: If automatic transaxle parts have been replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary. Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Motor Generator Control System: Check For Intermittent Problems
CHECK FOR INTERMITTENT PROBLEMS CHECK FOR INTERMITTENT PROBLEMS (a) Perform a simulation test. (1) For the simulation test, reproduce the driving conditions that were present when the problem occurred. These conditions should be based on the customer's comments and freeze frame data that is recorded ...