INSTALLATION PROCEDURE 1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY (a) Install a new gasket to the water inlet with thermostat sub-assembly. (b) Install the water inlet with thermostat sub-assembly with the 2 bolts and 2 nuts. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 2. CONNECT WATER BY-PASS HOSE (a) Connect the water by-pass hose and slide the clip to secure it. 3. INSTALL FRONT NO. 1 ENGINE MOUNTING BRACKET LH Click here 4. CONNECT ENGINE WIRE (a) Engage the clamp to connect the engine wire. (b) Install the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (c) Connect the water inlet with thermostat sub-assembly connector. 5. INSTALL NO. 2 ENGINE MOUNTING STAY RH (a) Install the No. 2 engine mounting stay RH to the intake manifold and front No. 1 engine mounting bracket LH with the bolt. Torque: 21 N·m {214 kgf·cm, 15 ft·lbf} (b) Connect the wire harness clamp bracket to the No. 2 engine mounting stay RH with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (c) Connect the wire harness clamp to the wire harness clamp bracket with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} 6. INSTALL ENGINE ASSEMBLY WITH TRANSAXLE Click here |
Toyota Avalon (XX50) 2019-2022 Owners Manual > Operating the lights
and wipers: Automatic High Beam
The Automatic High Beam uses a camera sensor located behind the upper portion of the windshield to assess the brightness of the lights of vehicles ahead, streetlights, etc., and automatically turns the high beams on or off as necessary. WARNING■Limitations of the Automatic High Beam Do not ...
