Toyota Avalon Service & Repair Manual: Installation

INSTALLATION

PROCEDURE

1. INSTALL ENGINE WATER PUMP ASSEMBLY

(a) Install a new water pump gasket and the engine water pump assembly with the 15 bolts.

Torque:

Bolt (A) :

43 N·m {438 kgf·cm, 32 ft·lbf}

Bolt (B) :

21 N·m {214 kgf·cm, 15 ft·lbf}

Bolt (C) :

11 N·m {112 kgf·cm, 8 ft·lbf}

Standard Length:

Item

Length

Bolt (A)

60 mm (2.36 in.)

Bolt (B)

55 mm (2.17 in.)

Bolt (C)

22 mm (0.866 in.)

NOTICE:

  • Make sure that there is no oil on the threads of the bolts (A) and (B).
  • Do not start the engine for at least 1 hour after installation.

2. INSTALL WATER PUMP PULLEY

(a) Temporarily install the water pump pulley with the 4 bolts.

(b) Using SST, hold the water pump pulley.

SST: 09960-10010

09962-01000

09963-00700

(c) Fully tighten the 4 bolts.

Torque:

21 N·m {214 kgf·cm, 15 ft·lbf}

3. INSTALL NO. 2 IDLER PULLEY SUB-ASSEMBLY

(a) Install the No. 2 idler pulley sub-assembly with the bolt.

Torque:

54 N·m {551 kgf·cm, 40 ft·lbf}

4. INSTALL V-RIBBED BELT

Click here

5. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

Click here

    Components

    On-vehicle Inspection

    See More:

    Toyota Avalon Service & Repair Manual > Electric Parking Brake System(for Hv Model): Control Module Communication Bus OFF (U0073,U0100,U0124,U0129,U0293)
    DESCRIPTION The parking brake ECU (brake actuator assembly) communicates with the hybrid vehicle control ECU assembly, skid control ECU (brake booster with master cylinder assembly) and deceleration sensor (airbag ECU assembly) via CAN communication. DTC No. Detection Item DTC Detection Condition Tr ...

    Toyota Avalon Owners Manual

    Toyota Avalon Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0121