REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VVT sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
PROCEDURE 1. REMOVE INTAKE AIR SURGE TANK ASSEMBLY Click here 2. REMOVE VVT SENSOR (for Intake Side of Bank 1)
(b) Remove the bolt and VVT sensor from the cylinder head cover sub-assembly. NOTICE: If the VVT sensor has been struck or dropped, replace it. 3. REMOVE VVT SENSOR (for Exhaust Side of Bank 1)
(b) Remove the bolt and VVT sensor from the cylinder head cover sub-assembly. NOTICE: If the VVT sensor has been struck or dropped, replace it. 4. REMOVE VVT SENSOR (for Intake Side of Bank 2)
(b) Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH. NOTICE: If the VVT sensor has been struck or dropped, replace it. 5. REMOVE VVT SENSOR (for Exhaust Side of Bank 2)
(b) Remove the bolt and VVT sensor from the cylinder head cover sub-assembly LH. NOTICE: If the VVT sensor has been struck or dropped, replace it. |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Panoramic View Monitor System(for Hv Model): System Description
SYSTEM DESCRIPTION GENERAL (a) This system has front, passenger side, driver side and television camera assemblies mounted around the vehicle to display around the vehicle on the radio and display receiver assembly. The multi-display also shows a composite view consisting of the area behind the vehi ...