REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during heated oxygen sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Click here 2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH Click here 3. REMOVE NO. 1 ENGINE UNDER COVER Click here 4. REMOVE REAR ENGINE UNDER COVER RH Click here 5. REMOVE HEATED OXYGEN SENSOR (for Bank 1)
(b) Disengage the wire harness clamp.
6. REMOVE FRONT FLOOR COVER LH Click here 7. REMOVE FRONT FLOOR COVER RH Click here 8. REMOVE BODY MOUNTING PLATE Click here 9. REMOVE NO. 1 EXHAUST PIPE SUPPORT BRACKET (for Lower Side) Click here 10. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) Click here 11. REMOVE HEATED OXYGEN SENSOR (for Bank 2)
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electric Parking Brake System(for Hv Model): System information not received (C13AE)
DESCRIPTION DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note C13AE System information not received Both of following conditions are met: Power switch on (IG) When power switch is first turned on (IG) after parking brake ECU (brake actuator assembly) has been replaced, system c ...