REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front brake flexible hose removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
NOTICE: If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position. HINT:
PROCEDURE 1. PRECAUTION (for HV Model) NOTICE: After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work. Click here 2. DISABLE BRAKE CONTROL (for HV Model) Click here 3. REMOVE FRONT WHEEL Click here 4. DRAIN BRAKE FLUID NOTICE: If brake fluid leaks onto any painted surface, immediately wash it off. 5. REMOVE FRONT FLEXIBLE HOSE
(d) Remove the clip and front flexible hose from the vehicle body. |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electric Parking Brake System(for Gasoline Model): Electric Current of Motor (C13A5,C13B0)
DESCRIPTION The following DTCs are stored when a malfunction occurs in the skid control ECU (brake actuator assembly). DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note C13A5 Electric Current of Motor An electric parking brake motor failure. Skid control ECU (brake actuator ass ...