INSTALLATION PROCEDURE 1. INSTALL REAR ENGINE OIL SEAL (a) Using height adjustment attachments and plate lift attachments, place the engine assembly on a flat level surface. NOTICE:
(c) Using SST and a hammer, tap in the rear engine oil seal. SST: 09223-15030 SST: 09950-70010 09951-07150 Oil Seal Protrusion Height: -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) NOTICE: Do not tap in the rear engine oil seal at an angle. 2. INSTALL NO. 1 CRANKSHAFT POSITION SENSOR PLATE
3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY
(b) Clean the 8 bolts and 8 bolt holes. (c) Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.
4. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Rear Seat Cushion Heater: Inspection
INSPECTION PROCEDURE 1. INSPECT REAR SEAT CUSHION HEATER ASSEMBLY (for LH Side) (a) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Specified Condition A-1 - K57-2 Seat heater temperature 23 °C (73 °F) 4.61 to 5.64 Ω A-1 - K57- ...