INSTALLATION CAUTION / NOTICE / HINT NOTICE: This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING) (a) Install a new gasket to the engine water pump assembly (water inlet housing). HINT: Be sure to clean the contact surfaces. (b) Install the engine water pump assembly (water inlet housing) to the cylinder block assembly with the 4 bolts. Torque: 43 N·m {438 kgf·cm, 32 ft·lbf} (c) Connect the engine water pump assembly (water inlet housing) connector.
(e) Using an 8 mm socket wrench, connect the sensor wire to the engine water pump assembly (water inlet housing) with the bolt. Torque: 10 N·m {102 kgf·cm, 7 ft·lbf} (f) Connect the sensor wire connector. 2. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY Click here 3. INSTALL INTAKE MANIFOLD Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Lighting System(for Hv Model Without Cornering Light): Hazard Warning Switch Circuit
DESCRIPTION The combination meter assembly receives the hazard warning signal switch (radio and display receiver assembly) on signal and controls the operation of the hazard warning lights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: When replacing the combination meter assembly, always replace i ...