REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during knock control sensor removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
NOTICE: This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts. Click here PROCEDURE 1. REMOVE INTAKE MANIFOLD Click here 2. REMOVE KNOCK CONTROL SENSOR
(b) Remove the bolt and knock control sensor from the cylinder block sub-assembly. NOTICE: If the knock control sensor has been struck or dropped, replace it. |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Park / Neutral Position Switch: On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. SECURE VEHICLE (a) Fully apply the parking brake and chock a wheel. CAUTION: Make sure to apply the parking brake and chock a wheel before performing this procedure. If the vehicle is not secure and the shift lever is moved to N, the vehicle may suddenly move, poss ...