DESCRIPTION The ECM illuminates the cruise SET indicator by sending indicator output demand signals to the combination meter assembly via CAN communication. The cruise SET indicator illuminates when the dynamic radar cruise control system is controlling vehicle speed. The cruise SET indicator light circuit uses CAN communication. If the cruise SET indicator is not functioning correctly, check for CAN communication DTCs before troubleshooting this circuit. CAUTION / NOTICE / HINT CAUTION: Observe the following items for safety reasons when using the Techstream:
NOTICE:
PROCEDURE
(a) Connect the Techstream to the DLC3. (b) Turn the engine switch on (IG). (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Combination Meter / Active Test. (e) Perform "Active Test" according to the display on the Techstream. Body Electrical > Combination Meter > Active Test
(a) Turn the dynamic radar cruise control system on using the cruise control main switch. (b) Drive at a speed between approximately 50 km/h (31 mph) and 180 km/h (112 mph). (c) Enter the following menus: Powertrain / Radar Cruise 1 / Data List. (d) Read the Data List according to the display on the Techstream. Powertrain > Radar Cruise1 > Data List
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Suspension Control Ecu: Components
COMPONENTS ILLUSTRATION *1 BAGGAGE HOLDER NET *2 SPARE WHEEL COVER ASSEMBLY ILLUSTRATION *1 LUGGAGE COMPARTMENT INNER TRIM PAD *2 LUGGAGE COMPARTMENT TRIM INNER COVER RH *3 NO. 1 LUGGAGE COMPARTMENT TRIM HOOK *4 REAR FLOOR FINISH PLATE ILLUSTRATION *1 ABSORBER CONTROL ECU *2 CONNECTOR N*m (kgf*cm, f ...