DESCRIPTION The ECM sends signals such as dynamic radar cruise control operation signals, brake operation demand signals and buzzer operation demand signals to the skid control ECU (brake actuator assembly) when the dynamic radar cruise control is operating. Therefore, if the skid control ECU (brake actuator assembly) detects a communication error with the ECM, it sends a malfunction signal back to the ECM.
CAUTION / NOTICE / HINT NOTICE:
PROCEDURE
(a) Using the Techstream, check if the CAN communication system is functioning normally. Click here
(a) Clear the DTCs. Powertrain > Radar Cruise1 > Clear DTCs(b) Make sure that the DTC detection conditions are met. HINT: If the detection conditions are not met, the system cannot detect the malfunction. (c) Check for DTCs. Powertrain > Radar Cruise1 > Trouble Codes
(a) Replace the ECM. Click here
(a) Clear the DTCs. Powertrain > Radar Cruise1 > Clear DTCs(b) Make sure that the DTC detection conditions are met. HINT: If the detection conditions are not met, the system cannot detect the malfunction. (c) Check for DTCs. Powertrain > Radar Cruise1 > Trouble Codes
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Meter / Gauge System(for Hv Model): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored. HINT: ...