INSTALLATION CAUTION / NOTICE / HINT NOTICE: If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor assembly with a new one. PROCEDURE 1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY NOTICE: If the front bumper assembly, radiator grill, millimeter wave radar sensor assembly or millimeter wave radar sensor bracket sub-assembly has been replaced, check that the beam axis change mechanism is at the standard position (centered).
(b) Engage the 2 guides.
(c) Tighten the 2 bolts and 2 screws on the millimeter wave radar sensor assembly. Torque: Bolt : 2.5 N·m {25 kgf·cm, 22 in·lbf} HINT: Tighten the bolts in the order shown in the illustration. (d) Connect the connector. 2. INSTALL COOL AIR INTAKE DUCT SEAL Click here 3. ADJUST MILLIMETER WAVE RADAR SENSOR (a) When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed. Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Smart Key System(for Start Function, Hv Model): Power Source Control ECU Malfunction (B2782)
DESCRIPTION The certification ECU (smart key ECU assembly) has a power source mode switching function. This DTC is stored when the IGE input (the steering lock motor activation permission signal) sent directly from the certification ECU (smart key ECU assembly) to the steering lock ECU (steering loc ...