REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced generator assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Replaced
PROCEDURE 1. PRECAUTION NOTICE: After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work. Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 3. REMOVE RADIATOR ASSEMBLY Click here 4. REMOVE V-BANK COVER SUB-ASSEMBLY Click here 5. REMOVE V-RIBBED BELT Click here 6. REMOVE GENERATOR ASSEMBLY
(b) Remove the nut and disconnect the wire harness from terminal B. (c) Remove the 2 bolts.
(e) Disconnect the compressor assembly with magnetic clutch connector. (f) Disconnect the camshaft timing oil control solenoid assembly connector. (g) Disengage the 3 wire harness clamps and remove the wire harness clamp bracket.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electronically Controlled Brake System(for Hv Model): Abnormal Brake Pedal Response on First Depression
DESCRIPTION If the vehicle has been stopped without opening or closing the driver door for a long period of time, the electronically controlled brake system will not be ready and sufficient fluid pressure may not be stored in the accumulator. In this case, the brake pedal response may not be the sam ...