Toyota Avalon Service & Repair Manual: Reverse Signal Circuit

Toyota Avalon Service & Repair Manual / Audio, Visual, Telematics / Audio / Video / Audio And Visual System(for Gasoline Model) / Reverse Signal Circuit

DESCRIPTION

The radio and display receiver assembly receives a reverse signal from the BKUP LP relay.

WIRING DIAGRAM

PROCEDURE

1.	CHECK BACK-UP LIGHT

(a) Move the shift lever to R and check if the back-up lights come on.

OK:

The back-up lights come on.

GO TO LIGHTING SYSTEM

2.	CHECK HARNESS AND CONNECTOR (REVERSE SIGNAL)

(a) Disconnect the G3 radio and display receiver assembly connector.

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever in R

11 to 14 V

G3-28 (REV) - Body ground

Engine switch on (IG)

Shift lever not in R

Below 1 V

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

REPAIR OR REPLACE HARNESS OR CONNECTOR

Registered Device cannot be Deleted

Satellite Radio Broadcast cannot be Received

See More:

Toyota Avalon Owners Manual > Driving procedures: Automatic transmission
Shifting the shift lever While the engine switch is in IGNITION ON mode and the brake pedal depressed*, shift the shift lever while pushing the shift release button on the shift knob. Shift the shift lever while pushing the shift release button on the shift knob. Shift the shift lever normally. When ...