Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: IG Power Supply Voltage (C1551)

DESCRIPTION

When a malfunction is detected in the power source circuit, the fail-safe function suspends power assist.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Warning Indicate

Return-to-normal Condition

Note

C1551

IG Power Supply Voltage

When the PIG power supply voltage is normal, the IG power supply voltage is 18.5 V or higher

  • Harness or connector
  • Rack and pinion power steering gear assembly

EPS warning light: Comes on

The ECU judges the system has returned to normal

-

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

  • If the rack and pinion power steering gear assembly has been replaced, perform assist map writing and torque sensor zero point calibration.

    Click here

  • Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - RACK AND PINION POWER STEERING GEAR ASSEMBLY)

(a) Disconnect the C67 rack and pinion power steering gear assembly connector.

*a

Front view of wire harness connector

(to Rack and Pinion Power Steering Gear Assembly)

-

-

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection

Condition

Specified Condition

C67-4 (IG) - Body ground

Power switch on (IG)

Below 18.5 V

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

2.

CHECK FOR DTC

(a) Clear the DTCs.

Chassis > EMPS > Clear DTCs

(b) Check for DTCs.

Chassis > EMPS > Trouble Codes

Result

Proceed to

DTC is output.

A

DTC is not output.

B

A

REPLACE RACK AND PINION POWER STEERING GEAR ASSEMBLY

B

USE SIMULATION METHOD TO CHECK

    Vehicle Speed Signal (C1541)

    PIG Power Supply Voltage (C1552,C1554)

    See More:

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Intelligent Clearance Sonar System(for Gasoline Model): Brake Hydraulic Pressure Malfunction (C164F)
    DESCRIPTION When a malfunction signal sent from the skid control ECU via CAN communication is detected by the clearance warning ECU assembly, DTC C164F is stored. DTC No. Detection Item DTC Detection Condition Trouble Area C164F Brake Hydraulic Pressure Malfunction Brake master cylinder brake fluid ...

    Toyota Avalon (XX50) 2019-2022 Owners Manual

    Toyota Avalon (XX50) 2019-2022 Service & Repair Manual

    © 2024 Copyright www.tavalon.net
    0.0148