Toyota Avalon (XX50) 2019-2022 Service & Repair Manual: IG Power Source Circuit

DESCRIPTION

When the engine switch is turned on (IG), the IG power source circuit supplies positive (+) voltage to the multiplex tilt and telescopic ECU.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE

1.	CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)

(a) Disconnect the G49 multiplex tilt and telescopic ECU connector.

*a	Front view of wire harness connector (to Multiplex Tilt and Telescopic ECU)

(b) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
G49-10 (IG) - Body ground	Engine switch on (IG)	11 to 14 V

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.	CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BODY GROUND)

(a) Disconnect the G49 multiplex tilt and telescopic ECU connector.

*a	Front view of wire harness connector (to Multiplex Tilt and Telescopic ECU)

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
G49-1 (GND) - Body ground	Always	Below 1 Ω
G49-8 (GND2) - Body ground	Always	Below 1 Ω

REPLACE MULTIPLEX TILT AND TELESCOPIC ECU

REPAIR OR REPLACE HARNESS OR CONNECTOR

Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Brake Booster Pump(for Hv Model): Installation
INSTALLATION PROCEDURE 1. INSTALL NO. 2 BRAKE ACTUATOR HOSE (a) Install the No. 2 brake actuator hose to the brake booster pump assembly and slide the clip to secure it. *a Identification Mark Front of the vehicle NOTICE: Make sure to connect the No. 2 brake actuator hose with its identification mar ...

Toyota Avalon (XX50) 2019-2022 Owners Manual