DESCRIPTION Different voltage values are sent to the multiplex tilt and telescopic ECU by operating the tilt and telescopic switch. The multiplex tilt and telescopic ECU then judges which motor and in which direction that motor should operate based on the voltage value. WIRING DIAGRAM PROCEDURE
(a) Turn the engine switch off. (b) Connect the Techstream to the DLC3. (c) Turn the engine switch on (IG). (d) Turn the Techstream on. (e) Read the Data List according to the display on the Techstream. Body Electrical > Tilt&Telescopic > Data List
OK: The value of each Data List item changes in accordance with the operation of the switch.
(a) Disconnect the G49 multiplex tilt and telescopic ECU connector. (b) Disconnect the G30 tilt and telescopic switch connector. (c) Measure the resistance according to the value(s) in the table below. Standard Resistance:
(b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Electric Parking Brake System(for Gasoline Model): Test Mode Procedure
TEST MODE PROCEDURE REAR BRAKE PAD REPLACEMENT MODE *1 Rear Disc Brake Piston *2 Nut *a The nut moves inward in pad replacement mode HINT: When replacing the rear disc brake pad and rear disc, since the nut inside the rear disc brake cylinder assembly is in an advanced position, it is necessary to m ...