CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE
| 1. |
VEHICLE BROUGHT TO WORKSHOP |
|
NEXT |
 | |
| 2. |
INSPECT AUXILIARY BATTERY VOLTAGE | Standard Voltage:
11 to 14 V (Power switch off) If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding.
|
NEXT | |
| |
| 3. |
CHECK CAN COMMUNICATION SYSTEM* | (a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here 
| Result |
Proceed to | | CAN DTCs are not output. |
A | | CAN DTCs are output. |
B |
| B |
 | GO TO CAN COMMUNICATION SYSTEM |
|
A | |
| |
(a) Check for DTCs. Body Electrical > Tilt&Telescopic > Trouble Codes
| Result |
Proceed to | | DTCs are not output. |
A | | DTCs are output. |
B |
| B |
| GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
A | |
| |
| 5. |
PROBLEM SYMPTOMS TABLE | (a) Refer to Problem Symptoms Table.
Click here
| Result |
Proceed to | | Problem symptom does not occur. |
A | | Problem symptom occurs. |
B |
| B |
| GO TO STEP 7 |
|
A | |
| |
| 6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU. Click here
(b) Data List / Active Test. Click here
|
NEXT | |
| |
|
NEXT | |
| |
| NEXT |
| END | | 
