INSTALLATION PROCEDURE 1. INSTALL ABSORBER CONTROL ECU (a) Install the absorber control ECU with the 2 nuts. Torque: 7.5 N·m {76 kgf·cm, 66 in·lbf} NOTICE:
(b) Connect the 2 connectors to the absorber control ECU. 2. INSTALL LUGGAGE COMPARTMENT TRIM INNER COVER RH Click here 3. INSTALL LUGGAGE COMPARTMENT INNER TRIM PAD Click here 4. INSTALL REAR FLOOR FINISH PLATE Click here 5. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Click here 6. INSTALL BAGGAGE HOLDER NET Click here 7. INSTALL SPARE WHEEL COVER ASSEMBLY Click here 8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL Click here NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here 9. PERFORM TEST MODE PROCEDURE NOTICE: After replacing the absorber control ECU, it is necessary to perform registration of vehicle identification information. Vehicle identification information is automatically acquired when the system enters test mode. Click here |
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Fuel Injector(for Direct Injection): Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY NOTICE: This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked. (a) Measure the resistance according to ...