Components COMPONENTS ILLUSTRATION
Installation INSTALLATION PROCEDURE 1. INSTALL LUGGAGE COMPARTMENT DOOR WEATHERSTRIP
(b) Align the joint of a new luggage compartment door weatherstrip with the luggage compartment door lock striker and temporarily install the luggage compartment door weatherstrip.
(c) Align the alignment marks on the luggage compartment door weatherstrip with the flanges on the vehicle body indicated by the arrows, and install the luggage compartment door weatherstrip. NOTICE:
HINT: Make sure to install the parts of the luggage compartment door weatherstrip near the joint and alignment marks shown in the illustration first, and then install the corners. 2. INSTALL REAR FLOOR FINISH PLATE Click here 3. INSTALL NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Click here 4. INSTALL BAGGAGE HOLDER NET Click here 5. INSTALL SPARE WHEEL COVER ASSEMBLY Click here Removal REMOVAL PROCEDURE 1. REMOVE SPARE WHEEL COVER ASSEMBLY Click here 2. REMOVE BAGGAGE HOLDER NET Click here 3. REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK Click here 4. REMOVE REAR FLOOR FINISH PLATE Click here 5. REMOVE LUGGAGE COMPARTMENT DOOR WEATHERSTRIP
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Sfi System: Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the power switch is then turne ...