Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE 1. INSPECT HAZARD WARNING SWITCH ASSEMBLY (RADIO AND DISPLAY RECEIVER ASSEMBLY)
(a) Check the switch. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance:
If the result is not as specified, replace the hazard warning switch assembly (radio and display receiver assembly). (b) Inspect the switch illumination. (1) Apply auxiliary battery voltage to the hazard warning switch assembly (radio and display receiver assembly) and check that the switch illuminates. OK:
If the result is not as specified, replace the hazard warning switch assembly (radio and display receiver assembly). Installation INSTALLATION PROCEDURE 1. INSTALL HAZARD WARNING SWITCH ASSEMBLY (RADIO AND DISPLAY RECEIVER ASSEMBLY) Click here Removal REMOVAL PROCEDURE 1. REMOVE HAZARD WARNING SWITCH ASSEMBLY (RADIO AND DISPLAY RECEIVER ASSEMBLY) Click here |
Toyota Avalon Service & Repair Manual > Blind Spot Monitor System(for Gasoline Model): Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor LH deviates more than the allowable range from the horizontal axis. HINT: If a drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor syst ...