REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model)
HINT:
PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE HEADLIGHT ASSEMBLY (a) Apply protective tape around the headlight assembly as shown in the illustration.
(b) w/o Cornering Light:
(2) Disengage the guide to separate the headlight assembly as shown in the illustration.
(3) Disconnect the connector to remove the headlight assembly. (c) w/ Cornering Light: (1) Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector.
(3) Disengage the guide to remove the headlight assembly as shown in the illustration.
|
Toyota Avalon (XX50) 2019-2022 Service & Repair Manual > Navigation Ecu: Installation
INSTALLATION PROCEDURE 1. PRECAUTION NOTICE: When replacing the radio and display receiver assembly or navigation ECU, always replace it with a new one. If a radio and display receiver assembly or navigation ECU which was installed to another vehicle is used, the following may occur: A communication ...