REMOVAL CAUTION / NOTICE / HINT
The
necessary procedures (adjustment, calibration, initialization or
registration) that must be performed after parts are removed and
installed, or replaced during headlight ECU sub-assembly
removal/installation are shown below. Necessary Procedure After Parts Removed/Installed/Replaced (for Gasoline Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link | |
Front bumper assembly |
- Measurement of ultrasonic sensor detection angle
- Ultrasonic sensor detection angle registration
|
- Intelligent Clearance Sonar System
- Intuitive Parking Assist System
|
 | |
Front television camera view adjustment |
Panoramic View Monitor System |
|
- Headlight assembly LH
- Headlight ECU sub-assembly LH
| Synchronize the vehicle information |
Lighting system (for Gasoline Model with Cornering Light) |
| Necessary Procedure After Parts Removed/Installed/Replaced (for HV Model) |
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function When Necessary Procedures are not Performed |
Link | |
Front bumper assembly |
- Measurement of ultrasonic sensor detection angle
- Ultrasonic sensor detection angle registration
|
- Intelligent Clearance Sonar System
- Intuitive Parking Assist System
|
| |
Front television camera view adjustment |
Panoramic View Monitor System |
|
- Headlight assembly LH
- Headlight ECU sub-assembly LH
| Synchronize the vehicle information |
Lighting system (for HV Model with Cornering Light) |
|
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE 1. REMOVE HEADLIGHT ASSEMBLY Click here
2. REMOVE HEADLIGHT ECU SUB-ASSEMBLY
NOTICE:
- Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
- If the headlight ECU sub-assembly has been struck or dropped, replace it with a new one.
| (a) Using a T25 "TORX" socket wrench, remove the 3 screws. |
|
| (b) Separate the connector cover from the headlight ECU sub-assembly. |
|
| (c) Disconnect the 2 connectors to remove the headlight ECU sub-assembly. |
|
3. REMOVE HEADLIGHT GASKET NOTICE: Make sure to replace the headlight gasket with a new one. Failure to do so may cause water ingress.
| (a) Remove the headlight gasket. | | | 
